Support
Why CS2 Footsteps Are Quieter Than Your Voice on Stream: Setting Up the OBS Mixer

How to Set Up the OBS Mixer So Your Voice Doesn't Overpower CS2 Footsteps

Why Your Voice Overpowers CS2 Footsteps

On stream, your voice usually comes across as closer and louder than the game: the microphone is right next to you, its signal is boosted by filters, and CS2 footsteps are naturally quieter than gunfire, grenades, and interface sounds. In your own headphones the balance may seem fine because the game plays directly from the system, and you also hear your voice without OBS monitoring.

The problem isn't always solved by raising the game volume. Footsteps will rise along with gunfire, explosions, music, and voice chat. In the end, the viewer will hear footsteps slightly better, but loud moments will start drowning out your voice or overloading the overall mix.

What Levels to Set in the OBS Mixer

Watch the OBS meter during actual gameplay, not the position of the sliders. For the microphone, normal conversational speech can reach roughly the −12 to −6 dB range. Occasional emotional outbursts may go higher, but they shouldn't constantly hit the red zone.

During a typical firefight, it's convenient to keep the game source about 6–10 dB below your voice. If your voice peaks at −8 dB, aim to keep loud game sounds around −18…−12 dB. Footsteps on the meter will be noticeably quieter, but they shouldn't disappear completely when you're calmly commentating a round.

First cut the excess volume from the microphone, then raise the game to the desired balance. This lowers the risk of overloading gunfire and explosions.

  • Don't judge the balance by the indicator color: the difference between sources at the same moment matters more.
  • Check the game while you're speaking, not in the pause between phrases.
  • Don't push the microphone and game to a constant maximum on the meter.

How to Level Out Source Volumes Without Overloading

Start a local recording in OBS and play through a typical gameplay episode: footsteps, gunfire, a grenade, and normal commentary. Adjust the microphone first. If calm speech already reaches −6 dB, lower the slider or reduce the gain in the filters by a few decibels.

Then raise the CS2 source in small steps. Don't focus on a single footstep sound: listen to what happens during gunfire. If the game approaches or overpowers your voice during shots, the overall game level is already too high.

The downside of this balance is that individual very quiet footsteps still won't sound like the main signal of the broadcast. You can't make them excessively loud without raising the rest of the game sounds.

Check the Gain and Compressor on Your Microphone

A common cause of the problem is aggressive voice processing. A gain filter raises the entire microphone signal, and a compressor makes quiet speech almost as loud as normal speech. If both filters are set too strong, your voice stays in the foreground even when you're speaking softly.

For a starting check, disable gain and the compressor one at a time, recording a short test after each change. If footsteps are more audible without the compressor, you don't need to raise the game right away: first ease off the microphone processing.

In the OBS compressor, you can start with a threshold around −18 dB and a 2:1 ratio. For speech, an attack within 5–10 ms and a release of 80–150 ms usually works well. Leave the output gain at zero until you've checked the result in a recording.

The downside of a gentle compressor is that your speech volume becomes less even. Quiet phrases may require more attention from the viewer, especially if the microphone is far away.

Microphone and light panels with sound visualization on a streamer's desk.

Don't Use the Compressor's Output Gain Without Checking

After compression, people often make the voice louder with the output gain parameter. This is handy if the compressor noticeably reduced the peaks, but this is exactly where it's easy to bring back the old problem: the processed voice becomes too loud relative to CS2 again.

First set the threshold and ratio, then record a clip without output gain. If your speech really did get quieter, add no more than a few decibels at a time and compare it with the game sounds each time. Don't raise the output level just because your voice seems quieter in your own headphones.

The downside of skipping the extra gain is that your overall voice may sound more modest, especially on a quiet microphone. This is safer than constantly overpowering the game, but it will require careful input level adjustment.

Turn Off Game Ducking by Voice

Check the filters on the CS2 source. If there's a compressor there with the microphone as the sidechain source, the game automatically gets quieter when you speak. For conversational content this is useful, but in CS2 the effect often hides footsteps exactly when you're commentating.

For a test, disable that filter entirely and make a recording with normal speech. If footsteps stop dropping out during phrases, you've found the cause. You can only keep the sidechain with a very gentle setting: a threshold above the level of quiet speech, a ratio around 1.5:1–2:1, and no strong output gain.

The downside of a disabled sidechain is that the game may interfere with long conversations. But for a competitive stream, constant CS2 ducking is usually worse than manual volume control.

Remove Duplicate Game Audio in OBS

CS2 can reach your broadcast through application audio capture, desktop system audio, or a separate output device. If two methods are active at once, the game audio can get louder, pick up latency, or suffer phase distortion. Sometimes one source is audible in monitoring but doesn't make it into the broadcast at the same level.

Keep one clear game source and temporarily disable the others. Then check the recording. If the sound changed, rebalance specifically for that capture setup. The downside of this approach is that after changing the audio device or CS2's output route, the source may need to be checked again.

Check the Result by Recording, Not by Monitoring

OBS monitoring doesn't always match what the viewer hears. The game may simultaneously go directly to your headphones at a different system volume, and the microphone may have its own monitoring level. So after setting up, record at least a minute of gameplay with commentary.

Listen to the clip without the game running and without active OBS monitoring. In the recording, footsteps should be distinguishable under calm speech, and gunfire shouldn't overpower your voice. It's useful to check the file on different headphones or on speakers: a headset with boosted low frequencies can hide balance flaws.

Don't aim for maximum footstep volume—aim for their audibility under your voice without overloading loud game moments.

OBS Mixer Setup Order Before Going Live

  1. Keep one CS2 audio source in OBS and disable any possible duplicates.
  2. Set the microphone so normal speech reaches roughly −12…−6 dB.
  3. Check whether the gain filter is adding extra loudness to your voice.
  4. Set up the microphone compressor with a gentle 2:1 ratio and no output gain.
  5. Raise the game so loud game moments stay 6–10 dB below your voice peaks.
  6. Disable the sidechain that ducks CS2 during speech and compare the recording.
  7. Listen to the test on a device you didn't use for setup.

Last Articles

New website design

What has changed in design and functionality We have updated the website to make working with it faster and more convenient. The main changes affect ..

15/08/2026 New

News SP

Good afternoon, I've collected all the news during this time.: 1. The main news is that prices for twitch viewers have been greatly reduced, while Tw..

08/04/2026 Update

We have collected all current promotions and giveaways for you until 01.01.2026

1. Use promo code "December2025" for a 15% discount for all our viewers2. We have reduced the base prices for our configurator and the most affordable..

26/12/2025 Ended

Cooperation with squads and resellers

Twitch services are working stably, so we are ready to cooperate with squads, resellers, service owners, bot owners, and many others.Individual te..

22/10/2025 For partners

Twitch viewers are stable, but there are some nuances.

We have completely updated our Twitch viewer services, and they are now working stably. We only use high-quality IP addresses for the viewers.The ..

22/10/2025 Update

Twitch Viewer Configurator and Control Panel

Hello everyone! Today, we are announcing a new feature—"Twitch Viewer Configurator". Now, you can customize any plan for your Twitch channel. Choo..

15/06/2025 New

If YouTube is blocked, where to stream now?

Greetings, I have compiled a guide for streamers, which will be very relevant at the moment. Now YouTube and twitch have disabled monetization from vi..

16/03/2022 Important

Reseller Panel API SP

We have finally developed the APINow it will be more convenient for our partner sites to work with us.To update the maximum tariffs for YouTube, an up..

02/09/2021 For partners

PARTNERS AND REFERRALS: NEW TERMS!

Due to the huge popularity of the partnership services and referral program, we have made a cooperation table. The essence is very simple: more live a..

12/08/2020 For partners

Viewer control panel [Twitch | Kick | YouTube | VK Video Live]

Build your own custom plan
Deposit funds, one-click order, discounts and bonuses are available only for registered users. Register.
If you didn't find the right service or found it cheaper, write to our support in Telegram or chat, and we will resolve any issue.
New

Telegram bot @BOT_SP_RU_BOT

Order or repeat in a minute, balance and order statuses — right in Telegram

Repeat orderOrder statusesBalance top-upPromo codes